![]() I replaced the fan first because my wife 9with the majic touch could tap the unit right. This is part of the cooling process of some projection televisions and is normal operation. Ive reseated the lamp 9about 6 month old) with no positive result. NOTE: If the television will not turn on immediately after being turned off, wait for the fan to finish its cycle, then attempt to turn it on again. To resolve this issue, ensure that the back of the television is well ventilated. * If the STANDBY light flashes four times in sequence, the television may be overheating. Reattach the lamp cover to resolve this issue. * If the STANDBY light flashes three times in sequence, the lamp cover is not securely attached. The number of times the STANDBY light flashes corresponds to a specific issue, some of which you may be able to resolve without the need for service. The self-diagnostic function of the projection television will cause the STANDBY light to blink or flash when the television detects an issue. The STANDBY light on the projection television is blinking or flashing. It is easy and safe to replace lamps and the lower lamp replacement costs reduces overall running costs. The system keeps operating with the remaining lamps if one goes out. Please note the number of times the STANDBY light flashes and relay that information to the service center. If the issue is still unresolved after following all of the troubleshooting steps, service may be required. If the issue is resolved, the problem is with the power strip or surge protector and not the television. NOTE: If the television is plugged into a power strip or surge protector, remove it from the power strip or surge protector and plug it directly into the wall outlet. Plug the power cord back into the electrical outlet. Let the television remain without power for 60 seconds.Ĥ. Unplug the television power cord from the electrical outlet.ģ. IMPORTANT: For a projection television that uses an internal lamp, wait 5 minutes after turning off the television to allow the lamp to cool before continuing with the following steps.Ģ. Some of these issues can be resolved simply by following the steps below to reset the television. The STANDBY light will flash if the television detects an issue within the television. The STANDBY light is flashing on the television and there is no picture or sound. I was trying to find some documentation on the flashing lights to see what sequence tells what the problem is. this is what I found on Sony's website (aside from you getting picture and sound)
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |